Winston WSW2.5-300 L, Installation & Operation Manual

Page: 15 / 20

7. Operation and Usage
7. Operation and Usage
24 25
Timer setting
1) The timer on/off setting operation at heating/ economic/ high requirements/ automatic mode
In the main interface
，
press
“ ”
hold on until the "tick" is heard "on" and "zone1" is
flashing
（
means the unit timer is on
） ，
press
“ ”
again and hold on until the "tick"is
heard "off" and "zone1"is flashing
（
means the unit timer is off
）
,press
“ ”
again and
hold on until the "tick" is heard "on" and "zone2" is flashing,and press
“ ”
again and
hold on
until the "tick"is heard "off" and "zone2" is flashes . You can select "on" and "zone1" to "off"
And "zone2"by pressing
“ ”or“ ”.
When ON(OFF) and zone1(1or2) are flashing
，
press
“ ”
and hours start to
flashing
，
then press
“ ”
to increase value or press
“ ”
to decrease value
，
press
“
”
again
to save the parameter setting;
At the same time, minute start to flashing
，
press
“ ”
to increase value or press
“
”
to decrease value
，
press
“ ”
again to save the setting.
During setting interface, you can cancel the current operation by pressing
“ ”.
In the timer-on/off setting interface
，
press
“ ”
to cancel the setting
（
The operation is
introduced in the following
）
.
Attention
：
If there is no operation for 5s
，
system will remember clock setting and back to
the main interface.
Timer 1 off has been set
2
）
.The timer on/off setting operation at vacation mode
In the main interface
，
press
“ ”
hold on until the "tick" is heard and "Timer" is
flashing. At this time
，
press
“ ”
and hour value flashes
，
the operation is the same
with Timer 1.
Attention
：
At vacation mode
，
if the unit is at booting state before the
timer setting, then the unit will be off when arrived the timer, and vice versa.
3
）
.The working periods setting at off peak mode
In the main interface
，
press
“ ”
hold on until the "tick" is heard and"on" is
flashing
，
press
“ ”
again and hold on until the "tick"is heard and "off" is flashing.
When "on/off" is flashing
，
press
“ ” ，
and hour value flashes, the operation is the
same
with Timer 1.
Attention
：
At off peak mode, during working periods, the unit runs economic mode, and the
system runs high requirement mode during other periods.
Cancel the timer setting
You can cancel the timer setting if there is no needing to set the timer.
In the timer setting interface, press
“ ”can cancel the timer.
The operations as follows
：
Long press
“ ”
Hours flashing
Press
“ ” Timer on
or
“
”
Press
“ ”
Press
“ ”
or
“
”
Timer off
Minute flashing
Press
“ ”
Press
“ ”
or
“ ”
Press
“ ”
Press
“ ”
or
“ ”
Press
“ ”