Operating Instructions
Container Heaters (0-90°C)
WOCP, WODPX, WODOK
Rev 1.1.2022-09
Winkler AG
▪
Englerstrasse 24
▪
D-69126 Heidelberg
▪
Tel. +49-6221-3646-0
▪
Fax: +49-6221-3646-40
▪
▪
www.winler.org
2 of 17
Contents
:
Disclaimer
All information - including illustrations and graphical representations - corresponds to our current state of knowledge
and has been written to the best of our knowledge. Specifications are subject to change without notice. In addition, we
reserve the right to make changes without notice to the design, materials or workmanship in the interest of technical
progress.
In these operating instructions you will find all the important information on mounting and
commissioning.In addition, you will find important information for your safety as well as for help in case
of problems.
The user of this product must decide on his own responsibility about its suitability for the intended use.
1.
Introduction
Container heaters are used to heat drums and IBC containers made of plastic or metal in order to protect the contents
filled in them from frost, to heat them to a certain processing temperature or to facilitate their removal and dispensing
by reducing their viscosity.
The heating element is installed within inside pockets, which ensures even heat distribution and gives the heating
jackets a structure that allows them to optimally fit the surfaces of the objects to be heated. They are equipped with a
hook and loop fleece to attach the digital temperature controller, which can be manually set to the desired temperature
of up to 90 °C.
The light weight heater has integrated insulation to minimize unwanted heat loss. Equipped with robust pull straps and
snap closures, they can be quickly and easily be attached to and removed from standard containers and drums.
Additional fastening straps or hooks prevent them from slipping off the container are provided with the heater.
With their relatively low specific surface power, they are only suitable to a limited extent for rapid heating of liquids or
melting of solid ingredients. Much more, they are ideally suited for frost protection as well as slow heating and
maintaining the temperature directly at the tapping point of already heated containers. Insulation lids are available as
accessories to improve the efficiency and protect personal against burns on the hot surfaces of the containers.
With their high-quality materials and workmanship, the heaters provide a safe, efficient and durable solution for heating
drums and containers in industrial applications when operated as intended.
Winkler, the Winkler Logo and the Winkler Red Dot Logo are registered trademarks of Winkler AG. All rights reserved.
