13
14
4.11 Making Tubing Connections
(Tubing is not Performance Tested or Certified by NSF)
1. Measure 3/4” from the end of each remaining piece of tubing (faucet end and inlet
end) and mark with a pencil (Check for roundness, smoothness, cuts, nicks, flat spots
and sharp edges.)
2. Push the tubing firmly into each fitting on the manifold until the line is flush with the
fitting collar. (If the tubing is removed, re-cut the end, measure, mark and re-insert).
Tubing must be fully inserted to avoid leaks (To remove tubing, depress and hold white
collet; pull tubing out to remove.)
4. Pull out slightly on tubing to ensure a good seal. Do no pull too hard or it may damage
related parts.
5. Install the other end of the tubing from the inlet side of the manifold to the feed water
adapter.
6. Insert plastic tab to ensure quick connect fitting cannot come as done.
CORRECT
end of tubing round and smooth.
with no cuts, nicks or flat spots
t
n
e
m
e
g
a
g
n
e
l
a
it
r
a
p
t
c
e
r
r
o
c
n
I
d
e
t
c
e
n
n
o
c
d
n
a
t
u
c
y
lt
c
e
r
r
o
c
g
n
i
b
u
T
correct full 3/4”
INCORRECT
4.12 Connect Water Lines
To connect the water lines, begin by taking the plastic supply line form the angle stop or saddle
valve and firmly connect it to the left most quick connect the on the top of the Fincel system
labeled “In”, Push the water line in completely and gently pull back out until it stops. Then
insert a blue locking clip to secure it.
Take the second feed line and repeat the process with the middle quick connect labeled "Out".
Leave the auxiliary cap in if you’re not using it to supply another faucet or appliance.
Take the free end of the second “Out” feed line and firmly attach it to the quick connect at the
base of the drinking faucet stem. Assure it’s properly connected like before and attach a blue
locking clip
Filtered Water
Faucet
Hot
Sink
Cold
Nut
Nut-tighten
if necessary
use to connect
tubing
Bottom
bolt
Handle
Valve
Insert
1/4”tubing
Ferrule
(Plastic)
Saddle Valve Connections
<Figure 4.10.3>
<Figure 4.11.1>
<Figure 4.11.5>
<Figure 4.11.2-4>
<Figure 4.10.4>
To Disconnect Tubing :
1. Remove plastic tab from fitting
2. Push the collet inward and hold with a finger while pulling the tubing out. Make sure
the collet is pushed evenly on all sides. If only one side is pushed the tubing will not be
able to be removed.
collet (depress to remove tubing)
tubing
IMPORTANT:
Remove plastic plugs from water line inserts.
