19
20
6.0 REPLACEMENT INDICATOR
6.1 FCSPU1 Indicator
The FINECEL Water Filtration System is equipped with a replacement indicator that measures
both total flow of water AND the length of time each filter has been in use. There will be both a
visual and audible signal to alert you to when each filter's life has been reached and when the
total system is nearing the recommended capacity of 400 gallons for carbon filters and 1200
gallons for UF filter.
Pre Filter/ Post Filter Indicator
It is recommended to replace pre filter and post filter cartridges at least every 6 months of
product water use. When the timer reaches 6 months, the LED indicator will turn on under
A and C on readout and the unit will beep intermittently. Indicator will be automatically
reset after replacing filter.
UF Membrane Filter Indicator
It is recommended to replace Ultra Filtration Membrane filter cartridge at least every 18
months of product water use. When the timer reaches 18 months, the LED indicator will
turn on under B on the readout and the unit will beep intermittently. Indicator will be
automatically reset after replacing filter.
Battery Indicator
When the timer reaches approximately 18 months of use, it will flash. At this time it is
recommended to replace battery. When the batteries are installed for the first time, the
indicator display will beep and flash all indicator lights to ensure the user they are
functioning correctly.
To change the battery, complete the following steps.
1. Push the “Open” button top of the filter case.
2. Press and slide open battery cover in red circle (shown below).
3. Insert batteries with proper po) and negative(-) alignment.
4. Close the cover.
5. Push the reset button “B” to reinitialize indicator.
(you can see the small hole around “B”, push it with fine wire for 3 seconds)
Pre Filter Indicator
UF Membrane Filter Indicator
Post Filter Indicator
Low Battery Indicator
Whole system
reset button
NOTE
If filters are replaced before the indicator light is activated, you must manually reset the
filter indicator lights. To do this insert a paperclip into the hole next to the
corresponding filter letter.
The large hole located to the far left of the indicator display is a full system reset. This
hole will be used if all three filters are changed before their indicator lights are active.
This allows for the user to reset all sensors simultaneously.
<Figure 6.1.1>
<Figure 6.1.2>
