Page 15 of 49
Document No.: 006020
Revision: P
OWNERS OPERATING & MAINTENANCE MANUAL
PHLEBOTOMY COLLECTION
Your Pivot Arm Assembly may be configured in one of two (2) directions:
•
Pivot point located near the back of the chair. This will provide arm
support that is straight or at a slight angle to the side of the patient
(standard position). (
FIG A
)
•
Pivot point located near front of chair. This will provide arm support
across the front of the patient’s body.
1.
If you wish to change the standard setup of the Pivot Arm (
FIG 1)
so that
the pivot point is toward the front of the chair, proceed to the next step.
Otherwise, skip this step. If you ordered Dual Pivot Arms, you can choose
which Arm(s), if any, you wish to alter. This change may be made before or
after Arm Assembly is installed on the chair.
2.
Use a Phillips or #2 square bit screwdriver to remove the four (4) wood screws on the underside of the
arm assembly that hold the pivot arm assembly onto the steel arm support.
3.
After removing the four (4) wood screws, rotate the steel arm support 180° (
FIG 2
).
4.
Reinstall the four (4) wood screws to secure the arm support in the new position (
FIG 3
).
FIG A
FIG 1
FIG 2
FIG3
PIVOT ARM PIVOT-POINT ADJUSTMENT
2570 / 2571
