Wiltron 680 B Series, Operation Manual

Page: 76 / 211

Setting
Power Level
Step Size There are two ways to set the step size of the power
level step that occurs after each frequency sweep–
set the step size or set the number of steps. The
step size range is 0.01 dB to the full power range of
the synthesizer; the number of steps range is 1 to
10,000. The power level step size is set from the
level sweep ramp menu.
To go to the Level Sweep Ramp menu from the
Level Sweep menu, press
Sweep Ramp .
This menu lets you set the step size and the number
of steps.
Press
Step Size
to open the step size parameter.
Press
Num of Steps
to open the number of steps
parameter.
Open the parameter you wish to change, then edit
the current value using the cursor control key or ro-
tary data knob or enter a new value using the key-
pad and appropriate termination key. When you
have finished setting the open parameter, close it by
pressing its menu soft-key or by making another
menu selection.
Press
Previous Menu
to return to the Level Sweep
menu.
LOCAL (FRONT POWER LEVEL
PANEL) OPERATION SWEEP OPERATION
RANGE
This error message is displayed
when (1) the step size value entered
is greater than the level sweep
range or (2) the number of steps
entered results in a step size of less
than 0.01 dB. Entering a valid step
size will clear the error.
680XXB OM 3-47