Step 10
Place the right side inner slide assembly
onto the instrument case with the handle
towards the front of the instrument.
Step 11
Insert two green-headed screws through
the holes in the slide assembly behind the
handle and into the metric tapped holes in
the side of the instrument.
Step 12
Insert two green-headed screws through
the holes near the rear of the slide assem-
bly and into the metric tapped holes in
the side of the instrument.
Step 13
Insert the two SAE threaded screws (re-
moved from the feet) through the 90
°
tabs
on the rear of the slide assembly and into
the rear panel of the instrument.
Step 14
Using the Phillips screwdriver, tighten all
screws holding the right side slide assem-
bly to the instrument chassis.
Step 15
With the appropriate hardware, install
the outer slide assemblies onto the equip-
ment rack.
Step 16
Lift the CW generator into position. Align
the inner and outer slide assemblies and
slide the instrument into the rack. Re-
align the hardware as needed for smooth
operation.
RACK MOUNTING KIT
INSTALLATION
INSTALLATION
Use two or more people to lift and move this equipment, or
use an equipment cart. There is a risk of back injury, if this
equipment is lifted by one person.
WARNING
2-12
680XXB OM
Changed: December 1996
Summary of Contents for 680 B Series
Page 5: ......
Page 11: ...Figure 1 1 Series 680XXB Synthesized CW Generator...