Wiltron 680 B Series, Operation Manual

Page: 58 / 211

Selecting a
Sweep Range Selecting a sweep range involves choosing a start
and a stop frequency for the frequency sweep. The
sweep range selection process is identical for both
the step and manual sweep frequency modes. There
are several ways you can select a sweep range, in-
cluding:
Editing the current start and stop frequency
parameter values.
Entering new start and stop frequency parame-
ter values.
Selecting one of the preset sweep range pa-
rameters (
F1-F2 , F3-F4 , F5-dF , or F6-dF) .
Editing the Current Start / Stop Frequencies
To edit the current sweep range start by opening
either the start or stop frequency parameter (in the
display above,
Edit F1 opens the start frequency pa-
rameter; Edit F2 opens the stop frequency parame-
ter).
Edit the open frequency parameter using the cursor
control key or the rotary data knob. When you are
finished, close the open parameter by pressing its
menu edit soft-key or by making another menu se-
lection.
Entering New Start / Stop Frequencies
To enter a new sweep range start by opening either
the start or stop frequency parameter (press
Edit F1
or Edit F2 ).
Enter a new frequency using the keypad and appro-
priate terminator key. When you are finished, close
the open parameter by pressing its menu edit soft-
key or by making another menu selection.
LOCAL (FRONT SWEEP FREQUENCY
PANEL) OPERATION OPERATION
RANGE
This error message is displayed
when the
dF value entered results
in a sweep outside the range of the
680XXB. Entering a valid value will
clear the error.
680XXB OM 3-29