8
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 or email: [email protected]. Hours: 7 am to 6 pm MST.
GooD: Rafter Mounting option
1 . Select a location in the buildings rafters where the outside Cradle
Antenna can be mounted directly above the Desktop Antenna with at
least 15 feet vertical separation . See Figure 7-2 on page 6 .
2 . Using the cradle as a template, position it on the rafter in the desired
location and mark the screw holes with a pencil .
3 . Drill two holes where marked, using a 3/16-inch bit and insert the
screw anchors .
4 . Line up the holes in the cradle with the screw anchors and mount the
cradle to the wall using two screws and two washers (see Figure 10
on page 7) . Tighten the screws with a Phillips-head screwdriver .
oK: Inside Window Mount (Packet C)*
1 . Select a location on the inside of the window as high as possible and at
least 20 feet from where the Signal Booster will be located .
2 . Clean the area on the glass with the supplied alcohol prep pad .
3 . Mount the outside Cradle Antenna using the suction cups provided in
Packet C . Using a twisting motion, press the suction cups into the two
holes on the antenna cradle (see Figure 11), then press the cradle onto the
glass at the desired location .
4 . Insert the antenna into the cradle
with the Wilson Electronics
insignia facing in the direction of the cell tower.
The cable
connection should protrude through the bottom of the cradle .
5 . Connect the supplied cable to the antenna and route the cable as desired to where the signal booster will
be located . Depending on the distance between the signal booster and antenna, you may need one or both
lengths of the supplied cable . If you use both, connect them together with the supplied cable connector .
Figure 11
antenna
and
Cradle
Suction cup
installation
*Note:
Window mounting the antenna will degrade the performance of your
system due to the metal oxide film applied to most windows. Most glass
windows have a metal film that reduces signal strength up to 20dB.
5 . Insert the antenna into the cradle
with the Wilson Electronics insignia facing in the direction of the
cell tower.
The cable connection should protrude through the bottom of the cradle .
6 . Connect the supplied cable to the antenna . Route the cable as desired to where the Signal Booster will be
located . Depending on the distance between the Signal Booster and antenna, you may need one or both
lengths of the supplied cable . If you use both, connect them together with the supplied cable connector .
