7
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660 or email: [email protected]. Hours: 7 am to 6 pm MST.
BETTER: outside Wall Mount (Packet B)
1 . Select a location on an outside wall as high as possible and at least 20
feet away from where the Signal Booster will be located (see Figure 9) .
2 . Using the cradle as a template, position it on the wall in the desired
location and mark the screw holes with a pencil .
3 . Drill two holes where marked, using a 3/16-inch bit and insert the screw
anchors .
4 . Line up the holes in the cradle with the screw anchors and mount the
cradle to the wall using two screws and two washers (see Figure 10) .
Tighten the screws with a Phillips-head screwdriver .
5 . Insert the antenna into the cradle
with the Wilson Electronics insignia facing in the direction of the
cell tower.
The cable connection should protrude through the bottom of the cradle .
6 . Connect the supplied cable to the antenna . Route the cable as desired to where the Signal Booster will be
located . Depending on the distance between the Signal Booster and antenna, you may need one or both
lengths of the supplied cable . If you use both, connect them together with the supplied cable connector .
Warning: RF Safety:
FCC regulations require that any antenna (inside or outside) used with this signal booster may not have
gain that exceeds 14 dBi . All Wilson Electronics antennas meet this requirement . Inside antennas must have at least 8 inches of
separation from all persons . Outside antennas must be farther than 30 inches from all persons .
!
Min . 15 Horizontal feet
(see page 5 for vertical)
Figure 9
Figure 10
antenna
and
Cradle
Cell
Tower
Cable Connector
Cable
