WILMS 3100430, Manual

Page: 7 / 34

Set up and transport of the unit
Introduction: This section provides information required for:
unwrapping the unit, making it ready for use and transportation of the unit.
Warning: If the dehumidifier has been laid down during transport, it is imperative to place it in
upright position for at least one hour before put into service!!!
Procedure: Follow these steps to unwrap the unit and make it ready for use:
Step Action Illustration
1 Open the cardboard box
on the top.
2 Place the cardboard box so
that the handle and wheels
are on the floor.
3 Pull the handle and wheel
of the dehumidifier out while
lying down.
4 Loosen the finger screws
and pull the handle up to the
desired height and tighten
the finger screws again.
5 Remove the protective film from the control panel.
Placing: Placement of the dehumidifier
Place the dehumidifier at a spot with good air circulation, where the minimum distance
from the air intake side should be 60 cm to the wall and from the air outlet side 3 m.
Also remember:
•
The ventilation openings must be kept free during operation.
6 of 33