All information, illustrations and specifications in these operating instructions are based on the latest information available at the time of
publication. We reserve the right to make design changes at any time without prior notification
51
8.0. Maintenance
8.2. Maintenance and inspection list
Maintenance
Interval
Area
Maintenance Task
First use after
5 hours
Machine
Check all moving parts and screws for
tightness.
First use after
20 hours
V-belt pulley tensioning
Initial check
See Chapter 8.7.
According to
grounds
Emptying flap
Open the lever and close it again; see
Chapter 7.5.
Membranes of filter unit
Empty by pressing
See Chapter 7.4.
Daily
Screen
Basic cleaning
Fine screen
Check for contamination or clogging.
Screen must be cleaned if the open
surface cross section is < 50%.
Filter insert
Rinse out cyclone filter with water and
allow to dry overnight.
Cardan shaft
Lubricate
(See separate universal-joint shaft
manufacturer's operating instructions)
Machine
Clean
As required
Wheels
Check air pressure
Cylinder broom
Adjust or reset
See Chapter 8.5.
Brush strips
If brush length is
(shorter than 90 mm) install new brush
strip set
See Chapter 8.6.
Weekly
Filter unit
(maintain regular maintenance
regulations and dry care conditions
Disassemble cyclone filter with water
and allow to dry overnight.
See section 8.4.
Lubrication points
Lubricate following the instructions in
Section 8.9.
100 hours
V-belt pulley tensioning
Carry out inspection following the
instructions in Section 8.6., retension if
required
Annually
Gearbox
Replace gearbox oil
Machine
Conserve
HONDA - engine
All information required for performing
maintenance on the Honda engine can
be obtained from the enclosed
manufacturer's operating instructions.
