background image

DEHUMIDIFIERS

DEHUMIDIFIERS

-15-

※ 

At least once per year, clean pump system

Basic-

1. Press the pump button (P) to drain water from reservoir.

2. Disconnect power to dehumidifier.

3. Mix a 16 oz solution of either 1 oz bleach to 15 oz water or 4 oz white vinegar to 12 

oz water. Pour into the drain tray at the base of the coils.

Note: If you get any cleaning solution on the coils, flush with water.

4. Allow to soak for 15 minutes.

5. Reconnect power to dehumidifier.

6. Fill reservoir and flush/cycle pump at least two times with clean water.

7. Repeat if needed or refer to Advanced instructions.

Advanced-

1. a. Use manual pump button“P”, to drain water from reservoir.

    b. Unplug the dehumidifier and open cover to access pump.  

    c. Pump head can be removed from reservoir by pressing on tabs.

  d. A wet-dry vacuum or towels can be used to remove remaining water from 

reservoir.

2. Fill pump reservoir with a diluted cleaning solution (15 oz water to 1 oz bleach or 12 

oz water to 4 oz white vinegar).

3. Reassemble pump and use manual pump button to flush mixtur e through discharge 

tubing.

4. Pour same diluted mixture slowly into drain pan under evaporator coil and allow it 

to clean hose from pan to pump. This process can be stopped when the pump energizes 1 

time.

Note: If you get any bleach/water mixture on coils, flush with water.

5. Pour sufficient clean water through drain pan to force pump to activate twice.

6. Reassemble unit and return it to operational status.

Coil-

If necessary, clean your coils with a vacuum or approved coil cleaner.

-14-

2. Water Pump Maintenance

The pump is designed with quick connection construction. If service is required, 

condensate tube, float switch connections, and the main power cord to pump can easily be 

disconnected.  The pump can be removed from reservoir by using a flat screwdriver to 

gently pry pump assembly from reservoir.

Your

 

WhiteWing SuperDry is equipped with an integral condensate pump designed to 

pump condensate from your dehumidifier out to the desired drain. This pump requires 

routine maintenance that is not cover ed by your 1 year parts warranty.  Only a defective 

pump will be repaired or replaced during the warranty period.

Preventative Maintenance

As with all pumps, preventative maintenance is necessary to prevent issues from dirt 

and slime that may accumulate in the drain system – including the drain pan, hose to the 

condensate pump, pump reservoir, pump head and float assembly, and discharge tubing.

Hand in this 

slot to open

Summary of Contents for SuperDry 90













Reviews: