DEHUMIDIFIERS
DEHUMIDIFIERS
SuperDry 90
※
Front View
Handle
Wheel
Front cover
Air inlet
Secured Access
Latch
Air Filter
-3-
※
Unit Overview
※
Control panel
Power Cord Input
Hose and
Cord Rack
Drain Tube
Connection
Air outlet
※
Rear View
-2-
How Your SuperDry Dehumidifier Works
The WhiteWing SuperDry Series Dehumidifier utilizes either its integral humidistat to
monitor the conditioned space or a manual on/off control to energize the compressor
when needed. Air is drawn across an evaporator coil. The evaporator coil is cooler than the
dew point of the air so water vapor will turn into liquid condensation. Air is then reheated
through the condenser coil and distributed back into the room.
Installation:
240 Volts AC may cause serious injury from electric shock.
WARNING!
1. Disconnect electrical power before servicing
2. Only plug unit into grounded electrical outlet
3. Do not use extension cord
4. Do not use plug adapter
Power Supply:
115V, 60 Hz AC Only 1 Phase
Outlet Requirement: 3-Prong, GFI
Circuit Protector: 15 Amp Time Delay Fuse or Circuit Breaker
Alternatively, you can manually control unit to operate independent of space conditions.
Place unit in desired location. The inlet of unit should be at least 8”from any
obstructions. If unit is transported in the horizontal position, allow it to sit in upright
position for at least 30 minutes before operating.
It is recommended that the unit be removed from any location where corrosive or high
VOC content materials are applied.
WARNING!
