www.whisperkool.com | Page 13
INSTALLING THE UNIT
From outside the cellar:
1. Apply air-tight sealant or caulking on the area of the unattached Intake Plenum that will contact the wall (as shown
in Figure 1).Make sure to seal all cracks and gaps. This will prevent heat transfer between the cellar and the adjacent
area.
2. Slide in and secure the unattached Intake Plenum to the wall from out side of the cellar using sheetrock anchors or
wood screws when going into a stud.
FIGURE 2
FIGURE 1
From inside the cellar:
3. Position the Rear Intake Plenum through the cellar wall. This will provide the intake on the condenser side of the
unit with fresh air.
It is not required to place the cooling unit directly against the cellar wall, however, having the unit as close to the wall
as possible is recommended.
FIGURE 3
