4-10
19. Remove the tub from the cabinet and
place it on its side on a plastic drop cloth,
then clean the excess grease off the tub.
18. Partially lift the tub out of the washer
cabinet and remove the following items
from the sides of the tub:
a) Wiring (remove standoffs).
c) Hang the end of the rods over the edge
of the tub, and tape them in place so
they do not fall off.
Hang Rods On Tub
b) Pressure switch hose (remove stand-
offs & cut wire tie).
c) Overflow hose (if present) and rubber
seal.
d) Four suspension rods and rubber snub-
ber straps.
Wiring Standoff
Pressure Switch Hose
Cut Pressure Switch
Hose Wire Tie
Overflow Hose Seal
b) Turn the suspension ball so the bend in
the rod is over the slot, and slide the
rod through the slot and the hole in the
cabinet gusset.
Turn Suspension Ball
& Remove Rod From
Slot & Gusset
Suspension Rod Assembly
