4-14
WARNING
Electrical Shock Hazard
Disconnect from electrical and gas supplies
before servicing unit.
Failure to do so could result in death, electri-
cal shock, or explosion.
CAUTION:
When you work on the range, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
Refer to Figure 4-11 for the following steps.
3.
Remove the right side panel as follows
(see inset #1). NOTE: The inset shows
installation of the left side panel, however,
the right side panel mounts to the range in
the same manner:
a) Remove the two screws from the rear
panel mounting tabs for the right side
panel.
b) From the back, push the side panel for-
ward as far as it will go and unhook it
from the screw at the top front corner.
c) Pull the top away from the range sev-
eral inches, then lift the panel free of
the retaining clips at the bottom.
4.
Press in on the locking arms while you
push out on the body of the oven light
switch, and remove the switch (see inset
#2).
5.
Unplug the three wires from the terminals
of the oven light switch.
REMOVING THE OVEN LIGHT SWITCH
1.
Turn off the gas supply and electrical
power to the range.
2.
Pull the range out from the cabinet far
enough to access the back panel.
Summary of Contents for GW395LEG
