95
94
Battery Diagnostics 2
Watts per Mile Raw
0 to 32767 W/m
Real time watts per mile calculation without
filtering
Watts per Mile
0 to 32767 W/m
Average watts per mile
Miles Remaining
0 to 300 Miles
Estimated miles remaining on charge
Ahrs Remaining
0 to 234 A hrs
Amp-hours remaining in the battery calculated
from a maximum of 234 Ahrs
Auxiliary Battery
0 to 20 DC Volts
Reading of auxiliary (accessory) battery: 12.5 to
13.9 volts is normal
Drive System Diagnostics
Motor Temp
-40 to 200
°
C
Temperature of the motor in
°
C; normal range max 140
Controller Temp
-40 to 100
°
C
Temperature of the controller in
°
C; normal range max 85
Motor RPM
0 to 9000
RPM
Revolutions per minute of the motor in real time
Encoder A
0 to 9000
RPM
Phase A encoder signal
Encoder B
0 to 9000
RPM
Phase B encoder signal
Throttle 1 Voltage
0 to 5.0 Volts
Normal range is .9 to 3.8 Volts
Throttle 2 Voltage
0 to 5.0 Volts
Normal range is .6 to 2.0 Volts
Brake Voltage
0 to 10 Volts
Indicates amount of brake pressure
Controller Fault
0 to 99
Indicates fault code
Climate Control Diagnostics
Temp Set Point
68 to 95
°
F
Sets desired cabin temperature
Cabin Temperature
0 to 150
°
F
Shows estimated cabin temperature
Evaporator Temp
-20 to 75
°
F
Shows the temperature of the AC evaporator
Low Pressure Switch
ON/OFF
ON indicates AC pressure is greater than 15 PSI
AC High Side
0 to 300psi
Shows high side pressure in the AC conditioning system
Compressor Speed
0 to 100%
Indicates the speed of the AC compressor
Condenser Fan
ON/OFF
When ON, the condenser fan is being commanded to run
Blower Input
ON/OFF
Should indicate ON when the cabin blower is running
Charging Diagnostics
J1772 PWM
0 to 50%
Indicates the pilot PWM coming from the charging station
I/O Diagnostics
Fie ld
Value
Mean ing
Brake Light Switch ON/OFF Should be ON if brake pedal is pressed
Start Switch
ON/OFF Should be ON when ignition switch is in the Start position
Accel Switch
ON/OFF Should be ON when Accelerator pedal is pressed
Econo Mode Sw
ON/OFF Should be ON when E button is pressed
Park Sw
ON/OFF Should be ON when shifter is in the Park position
Reverse Sw
ON/OFF Should be ON when shifter is in the Reverse position
Drive Sw
ON/OFF Should be ON when shifter is in the Drive position
Sport Mode Sw
ON/OFF Should be ON when shifter is in the Sport position
Motor Cooling Fan
ON/OFF When ON the motor cooling fan is being commanded to run
Summary of Contents for LiFe 2011
Page 1: ...owner s manual ...