Wheego LiFe 2011, Owner'S Manual

Page: 29 / 57

57 56
1. Attach the lower anchor strap to the two anchor
points located between the bottom cushion and the
back support. 2. Raise the head rest, put the strap(s) under it, then
attach to the rear anchor point on the lower back side
of the seat.
TIPS FOR GETTING THE MOST OUT OF YOUR CHILD RESTRAINT
• Before buying any restraint system, make sure that it has a label certifying that it
meets all applicable Safety Standards. The manufacturer also recommends that you
try a child restraint in the vehicle seats where you will use it before you buy it.
• The restraint must be appropriate for your child
’
s weight and height. Check the
label on the restraint for weight and height limits.
• Carefully follow the instructions that come with the restraint. If you install the
restraint improperly, it may not work when you need it.
• All passenger seat belts are equipped with cinching latch plates.
• Seat belts are designed to keep the lap portion tight around the child restraint so
that it is not necessary to use a locking clip. If the seat belt has a cinching latch
plate, pulling up on the shoulder portion of the lap/shoulder belt will tighten the belt
(the cinching latch plate will keep the belt tight; however, any seat belt system will
loosen with time so check the belt occasionally and pull it tight if necessary).
• If the belt still cannot be tightened, or if pulling and pushing on the restraint loosens
the belt, disconnect the latch plate from the buckle, turn the buckle around and
insert the latch plate into the buckle again. If you still cannot make the child restraint
secure try a different seating position.
• Buckle the child into the restraint exactly as the manufacturer
’
s instructions tell you.
• When your child restraint is not in use, secure it in the vehicle with the seat belt or
remove it from the vehicle. Do not leave it loose in the vehicle. In a sudden stop or
collision it could strike the occupants or seat backs and cause serious personal injury.