Wheatstone D-8000, Technical Manual

Page: 16 / 169

I N S T A L L A T I O N a n d P O W E R
page 1 – 5
D-8000 / Jan 2003
Once the supply is rackmounted, it should be connected to the console
using the factory supplied cable. The console’s two power supply connec-
tors are located at the rear of the console, one at each end of the meterbridge
bottom pan. If you are using two supplies (failsafe option) one supply will
connect to each console connector; otherwise only one connector will be
used (it does not matter which one). Note that the power supply cable’s 10-
pin female connector has to be rotated until its locating pins match the male
connectors on the console. Do not force a connector on; it attaches easily
when properly aligned. Connect the cable(s) first to the console, then to the
rear of the rackmount power supply.
Front view of the PSR
rackmount power supply
Power Supply
Console
End
End
E
D
F
H
PIN
1
2
3
4
PIN
8-pin Connector
Male
10-pin Connector
Female
Power Supply End Console End
G
A
C
B
5
VIO
GRN
BRN
YEL
ORG
BLK
BLU
RED
PS Cable Pinout
VIO
GRN
BRN
YEL
ORG
Phantom
6
BLK
7
BLU
8 RED
Digital Ground
Digital Ground
Analog Ground
-V in
+V in
D-8000 / Oct 2003