Part Number:
350092
Issue: 3
Page 25 of 125
© Copyright Westomatic Vending Services Limited 2020
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by
any means, electrical, mechanical, photocopying, recording or otherwise, without prior permission from Westomatic Vending
Services Limited.
9.2.5
Commissioning the flavour shots
Make sure that the correct flavour juice corresponds to
the button selection.
Connect bag-in-box connector to juice box by pressing
turning clockwise.
Prime each juice by pressing and holding the
corresponding flush button on the rear of the door until
the juice is at the dispense head.
9.2.1
Applying the recpie labels
If you require a different menu setup to the default one
supplied, then remove the 2 thumb nuts located on either side
of the menu light box.
If you want to remove the light box completely then also
disconnect the light power connector below the light box.
The menu box can now be completely removed from the
machine.
Tilt the menu box towards you and slide out the drinks menu
not required and insert a new one in its place.
See
section 13.3
on changing the drink recipe.
See section 13.2.13
for changing the button configuration.
Push the menu light box back up and replace the two black
thumb nuts to secure it in place.
Thumb nut
Light supply
