10
Mounting
5. Mount the protective hood (2) on
the provided holder, as shown in
the figure.
6. Use the included hex key to
tighten the hex screws.
Using the Shoulder Strap
The machine has to be operated with a suitable shoulder strap.
1. Hook the machine on the karabiner
hook and allow the machine to
balance on the shoulder strap. By
doing this, the machine must be
switched off.
2. For better stability, thread the end of
the strap over the buckle, as shown
in the picture. Tighten the end.
This will prevent the strap from
slipping out of the buckle due to the
weight of the device.
3. Slide the pin into the opening. Thus,
the carabiner hook is securely
fastened.
4. Pull out the pin to remove the carabiner hook.
Always switch off the machine before removing the karabiner hook
from the shoulder strap. Attention! There is a risk of accident.
Hang the machine on the karabiner hook. The cutting tool must
evenly touch the ground when working in comfortable working
position. If necessary, loosen the suspension eye (10) by using the
hex key, move it forth or back and re-position the suspension eye.
Summary of Contents for 92 21 48
