Programming
19
Before starting to program the gate opener, make sure the
moving rod is extended (when using one gate opener) resp.
both moving rods are extended (when using both gate
openers)!
EMERGENCY Release before Programming
1.
For releasing the motor and for pulling out the
moving rod, insert the triangular key into the
opening turn the triangular key counter clock-
wise. The motor is now disengaged and the
moving rod can be pulled out.
2.
Lock the motor after pulling out the moving rod
by inserting the triangular key into the opening
and turning clockwise.
Programming one Gate Opener
1.
As soon as the control box is connected to power mains, the display starts
flashing and shows
“
– –
“. Now the unit is in Standby.
2.
Hold the button
FUNC
pressed for more
than 4 seconds.
The display shows
P1
. The unit is in
setting mode for operating 1 resp. 2 gate
openers.
3.
Press the buttons
DEC
(for Decrease) in
order to start settings.
INC = Increase
DEC = Decrease
Setting
01
indicates operating mode for
gate opener 1 (view from inside of the
property
– Gate opener is mounted on the
right side of the gate).
Setting
10
indicates operating mode for gate opener 2 (view from inside of
the property
– Gate opener is mounted on the left side of the gate).
4.
Press the button
FUNC
in order to store the data
01
or
10
.
5.
The display shows
P2
. Please continue reading on page 21, chapter
P5
Adjusting the Blocking Force for Gate Opener 1
!
INC FUNC DEC