Lit. No. 72444, Rev. 05
100
April 1, 2021
MAINTENANCE
5. Replace the cutting edge when it is worn to
the bottom of the blade (PRODIGY™ and
straight blades) or within 1" of the carriage
bolts (MVP PLUS™ and MVP 3™ blades).
6.
Straight Blade, PRODIGY, WIDE-OUT™,
and WIDE-OUT™ XL Trip Spring
Adjustment:
To adjust trip spring tension,
adjust the eyebolts located at the top of the
blade. Loosen the locknut (nut closest to the
spring), and tighten the adjusting nut (the nut
farthest from the spring) until the coils begin to
separate. When tension is properly adjusted,
a sheet of paper should pass between the
second and third coils. When the proper
tension is reached, tighten the locknut.
7.
Blade Finish:
If the powder-coat
fi
nish is
nicked or scratched, repair the surface and
paint with WESTERN
®
red or black paint
(available in aerosol or quart can).
GREASING PIVOT PIN HINGE
MVP 3™ and ENFORCER™ snowplows:
Using
a rubber-tipped seal-o
ff
coupler, apply a good
quality multipurpose grease at the
fi
ve grease
points along the center pivot pin hinge.
Grease the hinge at the beginning of the
snowplow season. Reapply as needed during
the season and before putting the snowplow in
storage.
Grease
Points
Summary of Contents for UltraMount 2
Page 3: ......
