Page
7
of
14
All three servos need Dobro EZ connects
attached to them by enlarging the end
hole in the arm with a 1.5mm drill bit.
Make sure the EZ connect spins freely in
the servo arm.
Enlarge the holes in the three plywood
horns using a .9mm drill bit.
I recommend using the center hole on the
plywood elevator horn.
Glue the plywood aileron horns into the
slots provided as shown in the picture.
Glue the servo into the hole provided with
the arm centered straight down as shown
in the picture.
Attach the wire Z bend to the plywood
horn and EZ connect as shown in picture.