Page
11
of
14
After the FT has dried on the plywood
base plate, secure the wire landing gear to
the plywood base plate with the Zip-Ties
provided.
Then glue the 3-1/2” long 1.5mm rod
support trussing to the wing and base
plate as shown.
Cover the Zip-Tie and wire with FT glue to
add extra support.
Use FT to glue the square plywood support
piece on the outside of the nacelle to keep
the landing gear straight.
Cover the wire that pokes through the
square plywood with more glue.
Set the wing on a board to hold the top of
the fuselage up off the table.
Use a generous amount of FT glue to
attach the fuselage sides to the wing, and
make sure the sides are square to the
wing.
Allow to dry for at least an hour.
