Page
9
of
14
If metal X mounts are not included with
your motors, then use the square plywood
mounts supplied with the kit.
Glue the two plywood pieces together
with CA glue and attach to motor with
countersunk philips screws as shown.
The square plywood mount with the large
holes needs to face away from the motor
so that the screws fit flush.
The motors can now be attached to the
wing with screws.
Although we are using quadcopter motors
it is not necessary to have one left hand
threading and one right hand threading,
they can be both the same and either will
work.
The ESC and servo wires can now be
installed onto the wing and into the slot
provided.
Use a little hot melt glue to hold the ESC
and wires in place.
Servo wire extensions may be needed if
wires are too short to reach the receiver.
