Page
5
of
14
The landing gear is made of 2mm wire, use
a 2.1mm drill bit to enlarge the hole in all
three wheels and the plywood wheel
collars.
Then attach the wheels to the landing gear
using the plywood wheel collars and CA
glue. Do not get glue on the wheel, it
needs to spin freely.
Use the two metal wheel collars to hold
the nose landing gear to the plywood
pieces that you glued to the nose bottom.
The wire landing gear needs to turn freely
in the plywood.
The tail booms can now be glued with FT
to the wing as shown.
Make sure that the carbon spars are facing
in towards the center of the wing!
