Page
4
of
14
ESCs need to be soldered together as
shown using pieces of 18 gage wire. The
length of each piece of wire depends on
how much wire comes with your esc. Once
the wires are all connected they should
measure 13” long from one esc to the
other.
Do a test of the motors and ESC’s before
gluing them into the plane to make sure
they are working properly.
If both ESCs have a BEC, then the center
red power wire must be cut or removed
from
ONE
of the receiver plugs. This is
done so that the receiver gets power from
only one ESC.
The nose landing gear is held in place by
gluing with FT the two plywood pieces
(one on each side) to the foam piece with
a matching hole.
