58
OLED Display
8.1 Settings
A language can be selected for the OLED display from the language selection. This has no effect on the
internal website and is saved to the sensor automatically.
Language
Deutsch
English
Navigation with the keys:
:
Navigate up
:
Navigate down.
:
Selection is acknowledged with the enter key.
Meanings of menu items:
3
Zurück: Move up one level within the menu.
7
Run:
Switch to the display mode.
You can switch to the configuration menu by pressing any key.
NOTE!
If no settings are adjusted in the configuration menu for a period of 30 seconds, the sensor
is automatically returned to the display mode. The sensor accesses the last used menu view
when a key is once again activated. If a setting is configured, it becomes active when the
configuration menu is exited.
CAUTION!
Do not use any sharp objects to press the keys when configuring settings, because they
might otherwise be damaged.
8.2 Run
The sensor is switched to the display mode. Further information is available in section
.
The display
mode can be changed to the network mode, the I/O display or the Analysis mode in the display menu.
8.3 Operating Mode
Operating mode
Setting the operating mode of the sensor
Rot. Direction
Encod. Reset
3
Back
7
Run
Profile:
Smart:
Sensor works in "Profile" operating mode.
Sensor works in conjunction with the uniVision software.
(Notes in section
must be considered!)
Summary of Contents for weCat3D MLSL
Page 20: ...20 Technical Data weCat3D MLWL1x3 0 PP PP weCat3D MLWL1x4 0 PP PP weCat3D MLWL1x5 PP PP 0...
Page 22: ...22 Technical Data weCat3D MLWL2x4 0 PP PP weCat3D MLWL2x5 0 PP PP...
Page 24: ...24 Technical Data weCat3D MLWLxxx weCat3D MLWL1x1 weCat3D MLWL1x2...
Page 71: ...71 2D 3D Profile Sensors...
