44
Integrated Web Server
7.2.1 General Device
This is the sensor’s initial page which displays all relevant information concerning the device such as order
number, product version, manufacturer, description, serial number and MAC address, as well as hardware
and firmware version.
7.2.2 Device Settings
Content is subdivided into 3 categories:
Network settings
The desired address ranges can be entered to the
“IP Address”
,
“Subnet Mask
and
“Standard Gateway”
fields. These addresses permit operation, as well as communication between the sensor and your network
(PC).
CAUTION!
• If you don’t have access to information concerning available address ranges within your
network, contact your IT department first.
• Incorrect entries may result in network conflicts.
• The sensor’s IP address must differ from the IP address of the PC.
After the desired changes have been made, enter the web server password (
admin
) to the field and click
“OK”
. The changes are activated without restarting the sensor. In order to return to the integrated website,
enter the new IP address to your web browser’s address line.
NOTE!
If no password or an incorrect password is entered, a corresponding note will be dis-
played.
Summary of Contents for weCat3D MLSL
Page 20: ...20 Technical Data weCat3D MLWL1x3 0 PP PP weCat3D MLWL1x4 0 PP PP weCat3D MLWL1x5 PP PP 0...
Page 22: ...22 Technical Data weCat3D MLWL2x4 0 PP PP weCat3D MLWL2x5 0 PP PP...
Page 24: ...24 Technical Data weCat3D MLWLxxx weCat3D MLWL1x1 weCat3D MLWL1x2...
Page 71: ...71 2D 3D Profile Sensors...
