16
Attach Wing Panels
Refer to the installation drawings for wing panel placement.
1. Sweep the floor around the assembly area and place sheets of cardboard that shipped with the tower
onto the floor surface to protect the panel surfaces.
2. Place the wing with the finished surface facing down onto the cardboard and remove the tape holding
any protective paper to the face of the panels.
Orient the panels so the part number label is at the bottom.
Steps 3 and 4 are for non-access door wing panels only!
Wing panels that are access doors already have foam strips installed in the panels.
Wing panels that are not access doors will require foam strips to be cut and installed between the panels.
3. Cut a foam strip to span the entire width of the upper center panel and install it to be fully recessed into
the bottom edge of the panel.
4. Connect the upper and lower wing panels together.
a. Slide the panels together and align the edges.
b. Connect the two panel inner clips together using a 1/4-20 x 3-1/2" carriage bolt and 1/4-20 lock nut.
Tighten until just snug.
c. Repeat to connect the panels on the other side.
Tower Installation (continued)
Non-Access Door
Wing Panel
Orient panel so part number
labels are at the bottom
Panel Inner
Clips
1/4-20 x 3-1/2"
Carriage Bolt
1/4-20
Lock Nut
Clips
should be
touching
Sheets of
Cardboard
Foam
Strip
Access Door
Wing Panel
