Wellis Amazon W-Flow, User Manual

Page: 102 / 144

OPTIONAL ACCESSORIES - IN.TOUCH 2
102
PAIRING THE HOT TUB TRANSMITTER (CO MODULE)
AND THE HOME TRANSMITTER (EN MODULE)
The pairing process is used when you need to replace one module of the in.touch 2 kit. Otherwise, the in.touch 2
arrives pre-paired from the factory.
1. Power up the Home Transmitter
2. Press on the pairing button with a paper clip or some
similar tool. When the pairing mode is active the status
LED flashes YELLOW in a rapid pattern. The Home
Transmitter is then in pairing mode and will remain in
this mode until it pairs with an Hot tub Transmitter, or
until it is reset (power cycled).
3. Shut off the hot tub’s breaker (thus turning off the Hot
tub Transmitter), wait a few seconds, and then flip the
breaker back on. Within a few seconds, the pairing
operation should complete and the Home Transmitter
status LED will no longer be YELLOW.
Note: in.touch 2 modules can be paired as often as necessary, but can only be paired with a single counterpart mod-
ule at a time. Once paired, the modules store this information permanently until the next pairing operation. Pairing
information is stored in non-volatile memory, so pairing is not required after a power failure. Only a Home Transmitter
can initiate a pairing, so it is important that the pairing begin with putting the Home transmitter module in pairing
mode.
If several hot tubs are powered up at the same time with a Home Transmitter in pairing mode (for instance, in a dealer
showroom), only the 1st hot tub to successfully connect to the Home Module will pair. As this can be random, it is
recommended that only 1 hot tub be powered up at a time during the pairing process.
pairing button
status LED
Main electrical box GFCI panel