Welch Allyn IMAGETEAM 3800, User Manual

Page: 56 / 132

IMAGETEAM 3800 User’s Guide
6–4
Secondary Trigger Mode
Manual Trigger: You must press the scanner trigger to scan. When not
scanning, idle power is maintained. Default = Manual Trigger.
* Manual Trigger
Automatic Trigger: The scanner scans continuously at full power.
Automatic Trigger
Manual Trigger, Low Power: The scanner “sleeps,” using only 5 microamps,
until the trigger is pulled. When the trigger is pulled, the scanner wakes up and
operates at reduced power until there is no triggering for the time set with the
Low Power Time Out bar code. There is a short delay in operation when the
scanner is first triggered, but there is no delay when operating in low power
mode.
Low Power Time Out: Scan the Low Power Time Out bar code to change the
time out duration. Then scan the time out duration (from 0–300 seconds) from
the inside back cover and Save. Default = 2 minutes.
Note:
If you make an error while scanning the digits (before scanning Save),
scan Discard on the back cover, scan the Low Power Time Out bar
code, scan the correct digits, and Save again.
Manual Trigger, Low Power
Low Power Time Out
Note: The Secondary Manual Trigger, Lower Power option is not available on the
3800LR–11 in Secondary Non–Decoded Out Laser Emulation Mode.