Weishaupt WCM-EM 2.1, Installation And Operating Instruction

Page: 44 / 108

6.5.6 Configuration WCM-EM
This parameter is used to transfer the configuration information from the WCM-EM
to the WCM-FS.
Unit Config EM#2 Extension module #2
Heating circuit/DHW
HC pump
Pump heating circuit
no separate supply sensor connected
HC mixer Mixer heating circuit
separate supply sensor B6 connected
DHW
DHW load circuit
DHW sensor B3 connected
Pump PWM pump Version
PWM input connected or not connected
stage pump
External sensor
External sensor
Separate external sensor for zone control connected
Circulation sensor Circ ret sensor Circulation sensor B1 connected for shut off of circulation
pump
eBUS supply Auto Volt On Information about the status of the eBUS supply
Auto Volt Off
▶
Activate heating engineer level (see Ch. 6.5).
▶
Press function key
System info
.
✓
Menu
System info
is displayed.
▶
Use dial knob to move to the second menu level.
▶
Press function key
Config EM#2
.
✓
Parameter
Config EM#2
is displayed.
▶
Check configuration displayed.
▶
If the configuration is not the same, press function key
New
.
✓
The message
search config
appears briefly, then the current configuration is
displayed.
▶
Save new configuration with
OK
.
02
01
Heating engineer
System info
Commissioning
Setpoint temp system 8.0°C
Error history 00
System info
Heating circuit
End
End
-
+
New
OK
PWM-pump
External sensor
Auto Volt On
HC mixer
Config EM#2 336
Config EM#2
Installation and operating instruction
Remote control station WCM-FS 2.0 and extension module WCM-EM 2.1
6 Operation
83277502 • 3/2012-10 • La
44-106