weinor BiEasy 1MW-3V, Operating Instructions Manual

Page: 22 / 30

Explanation of functions
12 | EN
Explanation of functions
EN | 13
Status dis-
play
Oper-
ating
mode
display
Meaning
orange green Transmitter functions bidirectionally,
Operating mode Automatic
orange red Transmitter functions bidirectionally,
Operating mode Manual
green green Transmitter functions unidirection-
ally, Operating mode Automatic
green red Transmitter functions unidirection-
ally, Operating mode Manual
3 x orange
/red green Transmitter functions bidirectionally,
Operating mode Automatic,
Transmitter deleted
3 x orange
/red red Transmitter functions bidirectionally,
Operating mode Manual,
Transmitter deleted
3 x green
/red green Transmitter functions unidirectionally,
Operating mode Automatic,
Transmitter deleted
3 x green
/red red Transmitter functions unidirectionally,
Operating mode Manual,
Transmitter deleted
The transmitting power or radio range will be reduced by the
reduction in the performance of the battery. No more functions are
executed and there is no display, if the voltage drops below 2 Volt.
Group control
A group is understood to mean the control of several receivers
at the same time. The selected group is controlled by a travel
command. Any number of receivers can be programmed and con-
trolled in the channel.
The BiEasy 1MW-3V can be programmed into several receivers.
Selection button Auto/Manual
An already programmed transmitter (uni- or bidirectional) can be
switched between automatic and manual operation by using the
selection button.
The current mode of the handheld transmitter channel is queried
by briefly pressing the selection button.
Pressing and holding (for approx. 1 second) the selection but-
ton switches the automatic mode off. After the transmit signal,
the operating mode display lights up red. The receivers now only
carry out manual travel commands and do not respond to auto-
matic travel commands.
Pressing and holding (for approx. 1 second) the selection button
again, switches the automatic mode back on. After the transmit
signal, the operating mode display lights up green. The receivers
now execute automatic and manual travel commands.