EN | 17
Programming additional transmitters/channels
Programming additional transmitters/channels
NOTE!
If several receivers are connected to the same feed
line, then all are simultaneously in programming
mode. The shutters/blinds start a brief “random” up/
down travel. The longer you wait with the program-
ming, the greater will be the offset.
Individual transmitters/channels can now be
assigned to the respective receiver.
You can stop the brief up/down travel by briefly
pressing the
STOP
button on a transmitter which
has already been programmed.
The channel assignment/change can now be
made without having to disconnect the individual
receivers.
If the shutter/blind travels in the wrong direction,
delete the transmitter and reprogram it.
(
→
see Deleting a transmitter)
Programming additional transmitters/channels
Programming additional transmitters
To programme additional transmitters in one receiver, please pro-
ceed as follows:
1. Press the
UP
-,
DOWN
- and the programming button
P
simulta-
neously
(for 3 seconds). The status LED lights up briefly.
Push the programming button
P
on the new transmitter to be
programmed until the status LED lights up briefly.
2. Press the
UP
button
immediately
after the start of upward
travel (max. 1 second).
The status LED lights up briefly. The shutter/blind stops – starts
moving again – stops and then moves in the DOWN direction.
3. Press the
Down
button
immediately
after the start of down-
ward travel (max. 1 second).
The status LED lights up briefly. The shutter/blind stops.
The transmitter or the transmitter channel has been programmed.
Group mode
If more than 10 bidirectional receivers are being programmed
at the same time, the transmitter channel in programming mode
switches to group mode. The group mode is indicated by fast
flashing with pauses. Programming in group mode ends after a
2-minute pause or pressing the
STOP
button for 6 seconds.
16 | EN
