WEIGL ProCommander 2, Instruction Manual, Page: 67 / 87

Control.ini
67
The character after the t determines the way the time should
be interpreted.
m is the absolute time after powering on the ProCommander
LTC or after the insertion of a microSD card. After each removal
or new insertion of the card this time is set to zero.
&
means "modulo" which means, that any time the value is
reached the command is executed.
&05:00 means, that all 5 minutes the downstream command
will be executed.
c is the signal for external clock. So if an external clock is
connected, the specified value is compared to this clock.
Example:
!tm01:20 → if the time reached 1 minute 20 seconds after
the start-up or plug in of the card, then the following command
will be executed.
!t&05:00 → all 5 minutes the following command will be
executed.
!tc08:00 → at 8 o’clock (time from the external clock) the
following command will be executed.