WEIGL ProCommander 2, Instruction Manual, Page: 49 / 87

ProCommander LTC configuration
49
6 ProCommander LTC configuration
Additionally to the settings of the menu you can program the
ProCommander LTC via ASCII commands. This is very useful, if
you want to change settings via network, USB or commands
from a microSD card while operating.
6.1 USB port configuration
You can configure the ProCommander LTC via USB through a
terminal program, if the USB driver for the ProCommander LTC is
correctly installed on your PC, a COM port will be activated when
you connect them. If your driver is not already installed,
Windows will prompt you when you connect it to. Further
information you find under 4 USB – driver installation.
Now that you have started your terminal program and chosen
the activated COM port you can request the current settings
with the ASCII command
!?# . To control the ProCommander LTC
through a LAN-network the IP address and the port have to be
configured.
The required ASCII commands can be found here ASCII-chart .
6.2 Configuration via configurator
The ProCommander LTC can be configured easily, both
through USB and LAN-interface, with the help of the
configurator. Connect the device through USB- or LAN-wire with
your computer. You can download the configurator from the
Weigl-EM website.