Setup
1449820000/1.4/04.17
29
NOTE
•
The printer must be placed on a flat,
stable surface. The printer will not
operate properly if it is tilted or at an
angle.
•
Avoid locations that are subject to
strong fluctuations in temperature
and humidity.
Also see section “9.1
Technical data
•
Do not expose the printer to direct
sunlight, strong light or excessive
heat.
•
Avoid locations that are subject to
impact shocks or vibrations.
•
Do not use a table joined to other
tables in order to avoid the
transmission of vibration.
•
Avoid installation sites that are
subject to a large amount of dust.
1
Pay attention to the information given above.
2
Place the printer on a surface that extends
beyond the base area of the printer on all sides.
3
Leave enough space in front of the output rail to
allow the printer to output
MultiCards/MetalliCards without hindrance.
4
Install the printer in such a way that it is
sufficiently ventilated on all sides.
5
Install the printer near a power socket so that the
plug can be readily removed in the event of a
fault.
