9
11. Tap two 30mm Square Inner Caps (22) into each
open end of the left Fly Arm (25). Push a 1Ó
Round Inner Cap (24) into the end of the weight
tube. Slide a Weight Stop (28) onto the weight
tube.
Assemble the right Fly Arm (not shown) in the
same manner.
12. Press two Plastic Bushings (14) into the indicated
holes in the left Upright (1). Attach the left Fly Arm
(25) to the Upright using an M10 x 114mm Bolt
(19) and a Butterfly Knob (13). Make sure the Fly
Arm is on the outside of the Fly Arm Stop (15).
Attach the right Fly Arm (not shown) to the right
Upright (not shown) in the same manner.
13. Push a 3/4Ó Round Inner Cap (9) into the end of a
Short Pad Tube (12). Slide the Short Pad Tube
through the indicated hole in the left Fly Arm (25),
as shown. Push a Short Foam Pad (27) onto the
Pad Tube.
Repeat this step for the right Fly Arm (not shown).
14.
Make sure all parts are properly tightened
before you use the weight bench. The use of
all remaining parts will be explained in
Adjusting the Weight Bench starting on the
next page.
11
22
22
25
24
28
12
25
12
25
9
27
13
1
14
14
19
15
13
