6
ASSEMBLY
1.
Insert four M10 x 50mm Carriage Bolts (44) up
through the Right Rear Stabilizer (6). Attach the
Right Upright (9) to the Stabilizer with the
Carriage Bolts and two M10 Nylon Locknuts (40).
Do not tighten the Nylon Locknuts yet.
Repeat this step with the Left Rear Stabilizer
(5) and the Left Upright (8).
1
Before beginning assembly, make sure you
understand the information in the box
above. For help identifying small parts,
use the PART IDENTIFICATION CHART on
page 5.
5
6
40
40
9
44
44
8
To hire an authorized service technician to
assemble the weight bench, call toll-free
1-800-445-2480.
Before beginning assembly, carefully read the
following information and instructions:
•
Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
•
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
•
Tighten all parts as you assemble them, unless
instructed to do otherwise.
•
As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
•
Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
The included grease, and the following tools
(not included) may be required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Clear tape or masking tape
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. Most people find that set-
ting aside plenty of time helps assembly go
smoothly.