8
5.
Orient the Seat Frame (1) so that the hexagonal
holes are on the bottom. Attach the Seat Frame
to the Crossbar (2) with two M10 x 55mm Bolts
(53), two M10 Washers (41), two M10 Nylon
Locknuts (40), an M10 x 60mm Bolt (54), and an
M10 Nylon Locknut (40).
Do not tighten the
Nylon Locknuts yet.
6.
See the inset drawing.
Tighten the “T”-handle
(25) into the Seat Carriage (7).
Pull the “T”-handle (25) out as far as it will go and
slide the Seat Carriage (7) onto the Seat Frame
(1).
Attach the Front Leg (3) to the Seat Frame (1)
with four M8 x 55mm Bolts (46) and four M8
Nylon Locknuts (52).
Do not tighten the Nylon
Locknuts yet.
7.
Set the pins on the Adjustment Tube (14) down
into a set of brackets on the Left and Right
Uprights (8, 9).
Tighten the M10 Nylon Locknuts (40) used in
steps 1–5, and the M8 Nylon Locknuts (52)
used in step 6.
5
7
6
14
2
41
40
41
40
53
54
53
Hexagonal
Holes
1
3
46
46
1
7
52
52
Pin
Pin
8
9
25
7