24
Make sure that all parts are properly tightened each time the weight bench is used. Replace any worn parts
immediately. The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent; do not
use solvents to clean the weight bench.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight bench, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. See ADDING WEIGHT TO THE
WEIGHT CARRIAGE OR BARBELL in the ADJUSTMENT section of this manual. Add some weights to the
weight carriage.
To remove slack from the cable, remove the M10
Nylon Locknut (34) and the M10 x 48mm Bolt (33)
from the two Half Pulley Guards (109), the Small
Cable Trap (88), and the lower Small Pulley (87) near
the lower end of the two Pulley Plates (92). Reattach
the Small Pulley, Small Cable Trap, and Half Pulley
Guards to a hole closer to the center of the Pulley
Plates. Make sure that the Cable Trap is in the
proper position and that the Cable and Pulley
move smoothly.
Do not overtighten the cables. If a cable tends to slip off the pulleys often, it may have become twisted.
Remove the cable and re-install it. If a cable needs to be replaced, see ORDERING REPLACEMENT PARTS
on the back cover of this manual.
MAINTENANCE
34
82
109
109
33
87
88
