Diesel Gen-set Operation Instructions
61
Clean radiator
Clean oil cooler or replace core of oil cooler if it is blocked
Check and adjust angle of advance
Check tightness of air valve
Check if crankcase blows by and if belched some is blue,
replace piston ring when necessary.
Check wear of cylinder jacket, connecting rod bearing
shell and main bearing shell, etc.; and clean carbon deposit on
cylinder head, piston, combustion chamber and cylinder jacket.
II. Maintenance and care operation
1. Checking fuel, engine oil and coolant level
Fuel level: never operate the Gen-set when fuel level is lower than lower scale mark.
Fill proper amount of diesel oil into chassis fuel tank or daily-use fuel tank.
Engine oil level: as shown in Figure 9-1, never operate the Gen-set when engine oil
level is lower than L (low level) scale mark or higher than H (high level) scale mark.
When engine oil level is lower than L (low level) scale mark, fill engine oil of the
same grade until the level is between L and H scale marks; when engine oil level is
higher than H (high level) scale mark, drain proper amount of engine oil until the
level is between L and H scale mark.
Figure 9-1 Engine oil level