Wegener UNITY4000, Instruction Manual

Page: 58 / 75

UTY4000-003 B-8
R F L E V E L : O K
E B N O L E V E L : G O O D
RF xxxx may be HIGH, LOW, OK
EBNO LEVEL yy…yy may be GOOD, MARGINAL, ALARMING (see section 3.8.2)
R E T U R N
P r e s s < S E L E C T >
If NOT CURRENTLY TRACKING CARRIER:
M O D E : X X X X X X X X X X X X
D U R A T I O N : h H h : m m : s s
MODE xx…xx is current acquisition mode
DURATION hhh:mm:ss Elapsed time since this mode was entered, in hours, minutes,
seconds.
R F I N : 1 0 0 0 0 0 . 0 0
0 0 . 0 0 0 1 / 2
RF IN: n is only shown if optional RF switch is installed, otherwise omitted and fffff.ff fills to
left. The variable fields n , fffff.ff , dd.ddd , and r/r are defined in Settings Status above.
P R O G : p p p p p
T A G S I T E : t T
The variable fields ppppp and tt are defined in Settings Status above.
[ If tracking mode is entered while viewing any of the following three screens, the display will
jump to MODE & DURATION screen under TRACKING.]
S U B M O D E : x x X x x x x x x x x
SUBMODE xx…xx is carrier acquisition sub-mode.
The following two screens are shown only if applicaable (values non-zero):
N O M P E G : n n n A T T E M P T S
N O T A G : m m m A T T E M P T S