Wegener UNITY4000, Instruction Manual

Page: 53 / 75

B-3 UTY4000-003
F E C : x / x T A G : y y
P R O G : z z z z z
Where “ x/x ” is the inner FEC code ratio (1/2, 2/3, 3/4, 5/6, or 7/8); yy is the tag site. For
program designator, zzzzz is a number or wildcard ‘*’. Program designator field is left-justified
because length is variable. All edit sessions start on extreme left-hand numeric character. For
any character in the field, the up/down arrows scroll through all numeric characters 0-9, except
that the max allowed value will be ‘65535’. To select the ‘*’ wildcard (lowest program #
available), enter ‘00000’.
S A V E : < E N T E R >
C A N C E L : < S E L E C T >
<ENTER> saves the entry (new setting) and returns to 2nd level screens under “HARDWARE
SETUP>. <SELECT> returns without saving the entry.
B1.2.2 Channel Selection
Tunes IRD to a channel from settings table. Equivalent to a PERMCH
terminal command.
C H A N N E L S E L E C T : X X
Where “ xx ” is a Settings Table entry number between 1 and 48 inclusive. If the user presses
“Select”, then the ‘ xx ’ field flashes. Up/down arrows may select a new value. Pressing “Enter”
tunes the IRD to the new channel settings in that Table entry.
B1.2.3 Edit Channel
Edits an entry in the settings table. Equivalent to ADDS and DELS terminal commands.
E D I T C H A N N E L : x x
Where “ xx ” is a Settings Table entry number. If you press “Select”, then the ‘ xx ’ field flashes.
Up/down arrows then select a new value between 1 and 48. Pressing “Enter” starts an edit
session on the Table entry. The screens are the same as those under “Current Settings” above.
B1.2.4 Audio Settings
Similar to SETAUDIO terminal command.
A U D I O S E T T I N G S :
P r e s s < S E L E C T >
Moves user to 3rd level screens under “AUDIO SETTINGS.”