Wegener UNITY4000, Instruction Manual

Page: 56 / 75

UTY4000-003 B-6
P r e s s < E N T E R >
R E T U R N
P r e s s < S E L E C T >
Returns to Main level screens from “HARDWARE SETUP.”
B1.3 STATUS REPORTS
S T A T U S R E P O R T S
P r e s s < S E L E C T >
B1.3.1 Settings Status
S E T T I N G S S T A T U S
P r e s s < S E L E C T >
If RF switch option is installed:
R F I N : n f f f f f . f f a a a a
d d . d d d r / r h h : m m : s s
f f f f f . f f a a a a
d d . d d d r / r h h : m m : s s
T A G : t t a a a a
P R O G : x x x x x h h : m m : s s
R E T U R N
P r e s s < S E L E C T >
Settings Status report displays the current conditions and provides the following information:
Mode: aaaa is either PERM, TEMP, or SRCH settings. If TEMP, then hh:mm:ss is shown
and it is time remaining in insert.
RF IN:
n is the ( optional ) RF feed, 1-4.
FREQ (Mhz) { ‘-’ if searching }: fffff.ff is the carrier downlink frequency in MHz.
DATA RATE (Mbps) { ‘-’ if searching }: dd.ddd is the Transport data-rate in Mbps.
FEC Rate: { ‘-’ if searching }: r/r may be R= 1/2, 2/3, ¾, 5/6, or 7/8.
TAG SITE: tt is the tag site 0-15 (‘15’ is special value, see section 3.8.4)
Program: ppppp is up to 5 digit program number (see section 3.4)