Wegener UNITY4000, Instruction Manual, Page: 55 / 75

B-5 UTY4000-003
Where “xx...xx” is a six alpha-numeric character password for access via phone-modem.
Password field is left-justified because length is variable. All edit sessions start on extreme left-
hand character. On each character, the up-arrow will scroll through all alpha-numeric characters
as well as null. However, all nulls, or nulls to the left of valid characters will not be accepted
when “Enter” is pressed.
P R I N T E R S E T T I N G S
B A U D x x x x x P A R I T Y y
bb…bb is baud-rate in bps, p is parity, either O , E , or N . See section 3.7 for details and limits.
M O D E M S E T T I N G S
B A U D x x x x x P A R I T Y N
bb…bb is baud-rate in bps, p is parity, either O , E , or N . See section 3.7 for details and limits.
A U X D A T A P I D : p p p p p
B A U D b b b b b P A R I T Y p
ppppp is the PID of the selected data-stream in hex , bb…bb is baud-rate in bps, p is parity,
either O, E, or N. See section 3.7 for details and limits.
R E T U R N
P r e s s < S E L E C T >
Returns to 2nd level screens under “HARDWARE SETUP.”
B1.2.7 LNB LOs
If no optional RF Switch is installed:
L N B L O : x x x x x . x x
Where fffff.ff is the frequency presumed for the LNB LO (in MHz).
or… if optional RF Switch installed, two screens are shown, each as below:
L N B L O : x x x x x . x x n
L N B L O : y y y y y . y y m
Where n and M are RF feed numbers, and xxxxx.xx and yyyyy.yy are the respective LNB LO
frequencies (in MHz).
B1.2.8 Unit Reset
T O R E S E T U N I T