Wegener UNITY4000, Instruction Manual

Page: 48 / 75

UTY4000-003 A-4
The audio program is routed to the audio port port’s audio switch, and is then routed to the Left
and Right outputs according to route .
A1.1.12 SETLNB LO_freq
LO_freq: This value represents the LNB LO frequency in MHz. It can have up to two decimal
places and its valid range is from 0 to 14000.00.
Sets lnb_lo_freq to
LO_freq .
A1.1.13 SETTIMEOUT source time
source: 1 - Fade
2 - Installation
3 - Carrier Search
4 - No COMPEL
5 - Header Seek
6 - Header Search
time: Time-out value in HH:MM:SS format. Valid range up to 4660 hours (except 30 seconds for fade).
Timeout. source is set to time . The timeout sources are defined as follows: (1) FADE timeout: The amount of time
that the unit software will allow the receiver card to re-acquire a faded carrier “on its own” without some
intervention. (2) INSTALLATION Timeout: The amount of time that the unit will attempt to initially acquire (or,
after FADE timeout) re-acquire the carrier before searching for alternate carriers found in the Settings Table (called
“Carrier Search” mode). (3) CARRIER SEARCH: The amount of time the unit will remain in CARRIER SEARCH
before attempting SATELLITE SEARCH mode [
not defined currently ]. (4) NO COMPEL: The amount of time the
unit will remain parked on a carrier after it has last received a valid COMPEL network header before attempting to
re-acquire carriers in its Settings Table to see if they carry valid COMPEL network traffic (called HEADER
SEARCH mode). This is only applicable to IRDs whose COMPEL REQUIRED status is REQUIRED.
(5) HEADER SEEK: The amount of time a unit in HEADER SEARCH mode will loiter on a carrier it has acquired
awaiting valid COMPEL pack headers before proceeding to attempt the same on other carriers in the Settings Table.
If it acquires a valid COMPEL header, it reverts ot TRACKING mode. (6) HEADER SEARCH: The amount of
time the unit will remain in HEADER SEARCH before attempting SATELLITE SEARCH mode [
not defined
currently ].
A1.1.14 SNR alarm_level margin_offset
alarm_level: Units of dB with range from 5.0 - 14.9 and can have one decimal place.
margin_offset: Units of dB with range from 1.0 - 10.0 and can have one decimal place.
Sets alarm_level and margin_offset accordingly.
A1.1.15 TEMP settings time
settings: See Perms/Temps/Searching & Settings Section.
time: Length of insert in HH:MM:SS format. Valid range is 00:00:00 to 18:00:00.
Will handle data rate rounding as explained for PERM. Unit sets its temp_settings to settings .
See Perms/Temps/Searching & Settings Section for more information.
A1.1.16 TEMPCH location time
location: Value from 1 - 48 indicating location in settings_table.
time: Same as for TEMP.